Believe that many new contact with the push-button plug and pull force testing machine customers, for its operation method is not very skilled. The seller may teach you a few times will also feel tired, and you have not seen whether it is very distressed, don't worry about lenx detection and the majority of users to share the use of the key plug and pull force tester, hope to be helpful to the user is using the key plug and pull force tester.
1. Enter the computer program, operate the number key on the control panel, select the walking speed (mm/min) of the machine's transverse gear, and then press the "up" or "down" key to adjust the position of the transverse gear.
2. After selecting the right clamp and installing it properly, set up the upper and lower safety limit screws, especially the setting position of the upper limit screws, so as to avoid the impact of the lower clamp on the upper clamp and damage to the load element when the specimen is broken and the machine rises back automatically.
3. After setting the required conditions and specimen specifications, the test can begin.
Please refer to the computer system operation manual for the software operation section.
Pay attention to
■ after clamping, the specimen should be vertical and free from tension.
■ the jig used for different materials cannot be used universally.

Each member of lenx testing sticks to his/her post, adhering to the attitude of "quality comes from precision, quality creates the future"; Seriously to the customer assigned to do every piece of work. Active and responsible and good after - sales service, in order to make consumers can buy happy, assured. The pursuit of "comprehensive customer satisfaction" is the goal of every lenx tester.