The abrasion testing machine is used for painting various products, and the surface of wire brush is used for abrasion testing. The equipment uses pencil, eraser and alcohol cotton cloth as test fixture, 50-1000g weight as load for test, and two groups of tests can be carried out at the same time. It is a special test equipment with convenient adjustment and obvious effect.

Parameter specification:

1. Tools: pencil, eraser, alcohol cotton

2. Weight: 50g, 100g, 200g, 300g, 500g

3. Speed adjustment adopts LED times / minute digital display, 5-120vpm / mm (adjustable)

4. Moving range: 0-40mm (adjustable)

5. Maximum load: 5kg

6. Count value range: 0-999999 (settable)

7. Power supply: 220V, 50Hz, 2A

8. Two groups of tests can be carried out at the same time

Usage method

1. Fasten the test piece with clamp block, with the printing surface facing up.

2. Use tools and weights to press flat on the printing surface.

3. Power on

4. Set the number of times required by the product and set the counting method as follows (setting method: press the displacement key "→" and the value displacement key "↑" to modify the number of times you need, wait for 8 seconds, press "set" to reset

5. Set the speed adjusting knob to the minimum

6. Press the start key to adjust the speed to the required value

Points for attention

1. Lay the equipment flat on the ground

2. Keep the equipment dry and clean

3. Add lubricating oil to the mechanical movement place

4. Unplug the power cord after the test is stopped